Custom Search
|
|
|
|||||
|
|||||
 1) Turn he change key RIGHT and remove it from the lock.
The new
combinaton is now set.
m) Work the new combination at least three times with the door or
container open. If the lock cannot be opened using the new combination, it
can be assumed that the new numbers were not set correctly. If this is the
case, call for a qualified locksmith.
3.2.5.4
Strike Installation. Strikes designed for use with the Sargent &
Greenleaf 8470MP are illustrated in Figures 19 through 22.
a) Using the template provided with the strike, position the strike
on door jamb or inactive leaf of double door configuration (depending on which
strike is being used).
b) Drill holes for attaching the strike using No. 25 drill bit
(0.149-inch (4-mm) diameter).
c) Using No. 10 flat head machine screws, install the strike on the
door jamb (for strike No. 1, 2, or 3), or on the inactive leaf of the double
door configuration (for strike No. 9).
3.2.5.5
Lock Installation Procedure (8400 Series). The Sargent & Greenleaf
8470MP is designed for use with the Sargent & Greenleaf 8400 and 8500 Series
Combination Locks. If the 8470 is equipped with an 8400 Series lock, proceed
with step a) below. If it has an 8500 Series lock, refer to the procedure in
paragraph 3.2.5.6.
a) Use the center of the strike as a reference to position the lock
template on the door.
b) Using the template (provided with lock), drill the six 8470
deadbolt base-attaching screw holes (0.149-inch (4-mm) diameter for self-
tapping screws). Drill the hole for the spindle shaft (0.813-inch (21-mm)
diameter if lock has a tube, 0.625-inch (16-mm) diameter if lock does not).
c) Securely fasten the 8470 deadbolt base and drill resistant hard
plate to the door by tightening the attaching screws.
If the lock has a tube, proceed with step d). If not, go to step j).
d) Make sure bolt is in the locked or engaged position. To
accomplish this, rotate the dial left to O. Turn the arrow knob in the center
dial to O, and rotate the dial left four revolutions, stop at random.
e)
Remove back cover of the lock.
Place
f) Insert tube and hold lock against the 8470 deadbolt base.
dial ring on tube and tighten tube nut.
32
|
 
|
||||
|
|||||
