Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Custom Search
 
  
 


MIL-HDBK-1013/1A
Table 48
Transparent Armor Capable of Defeating the High-Severity Threat
+)))))))))))0)))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))),
* Thickness *
*
Construction
/)))))))))))3))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))1
*1.39
* Goodyear laminated transparent armor (Type 73-30) consisting
*
*inches
* of two 0.5-inch (12.7-mm)-thick plies of soda-lime plate glass
*
*(35.3 mm)  * (front) and one 0.25-inch (6-mm)-thick ply of polycarbonate
*
*
* (rear).  Total thickness of adhesive between plies is 0.1 inch
*
*
* (2.5 mm).  Exterior of rear is coated with 0.04-inch (1-mm)-
*
*
* thick compound to protect polycarbonate from abrasion.
*
/)))))))))))3))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))1
*1.75
* NCEL transparent sandwich (described in 6.5.2.2(4)(c), above)
*
*inches
* consisting of six 0.25-inch (6-mm)-thick plate glass plies
*
*(44.5 mm)  * (front), 0.5-inch (12.7-mm)-thick air space, one 0.25-inch (6-
*
*
* mm)-thick Lexan sheet (rear); transparent adhesive (between
*
*
* glass plies) and air space.
*
/)))))))))))3))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))1
*2.00
* Amerada glass (also known as Safe-Ray glass) consisting of
*
*inches
* eight 0.25-inch (6-mm)-thick plate glass laminae; transparent
*
*(50.8 mm)  * adhesive between laminae.
*
/)))))))))))3))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))1
*2.12
* Armaglas (series T, level 4) consisting of 0.5-inch (12.7-mm)-
*
*inches
* thick plate glass laminate (front), 1-inch (25-mm)-thick
*
*(53.8 mm)  * acrylic (intermediate), and 0.375-inch (9.5-mm)-thick
*
*
* polycarbonate (rear); transparent adhesive between laminae.
*
.)))))))))))2))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))-
resistant roof scuttles and skylights for the required severity threat level
or eliminate skylights.  As an alternative for the high level of protection,
provide high bullet-resistant parapet walls to block sightlines as shown in
Figure 67.
6.5.3
Protection Measures: Retrofit.
Retrofit protection measures are
components and building systems added to the existing facility construction.
Moving of assets to more secure or secluded areas is another method for
enhancing protection.  Retrofit measures are discussed in the following
paragraphs.
Walls.
There are three methods for upgrading existing walls.
6.5.3.1
First, a stand-up reinforced concrete wall section can be added either to the
outer or inner surface of an existing wall.  A wall thickness equal to the
wall section necessary to prevent single-round impacts at published muzzle
velocities is recommended, although thinner add-on wall sections could be
used if the composite (existing wall plus add-on section) wall is tested
against the projectile threat and proven to be effective.
210








Western Governors University
 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business