Figure 13. Sargent & Greenleaf 8500 Series, Drive Cam with Spline Key Inserted

Custom Search

Back

INSERT FIGURE

Figure 13

Sargent & Greenleaf 8500 Series, Drive Cam with

Spline Key Inserted

s) Rotate the dial at least one complete revolution and stop at O.

The accelerator spring should now be in the loaded position.

t) Hold the cover in place on the lock and push the dial in at O.

Release the dial. Remove the cover and check the position of the accelerator

spring (spring should be in the released position). (If the accelerator

spring is not in the released position, the dial has not been backed out of

the cam far enough and the condition must be corrected. Remove spline key,

hold cam and rotate dial one additional full turn counterclockwise. Reinstall

the spline key and repeat steps.)

u) Rotate the dial at least one complete revolution and stop at 50.

The accelerator spring should now be in the loaded position.

v) Hold the back cover in place on the lock and push the dial in at

50. The accelerator spring should not release. (If the accelerator spring

does release, the spindle must be turned clockwise into the cam one complete

revolution and this step must be repeated.)

w) Dial the set combination (50-25-50) on the lock and observe the

drop lever falling into the drive cam. Repeat this step at least three times.