Custom Search
|
|
|
||
 7.10 NAVFAC DRAWING NUMBERS
NAVFAC Drawing Numbers shall be obtained from the PDE or PWC Code 411, Design and
Engineering Department Plan Files, when the total number of sheets in the contract has been
firmly established. Generally, this is just prior to submission of the Pre-Final Submittal.
7.11 CONSTRUCTION CONTRACT NUMBER AND SPECIFICATION NUMBER
The construction contract and specification numbers will be indicated in the "Scope." DO not
confuse the construction contract number with the A-E contract number.
7.12 SHEET NUMBERS
On the first and last drawings, show the chronological sheet number together with the total
number of drawings in the set. For example, if there are a total of 127 sheets in the set of
drawings, the first sheet shall be designated "Sheet 1 of 127" and the last shall be designated
"Sheet 127 of 127." All other sheets shall show only the chronological sheet number (e.g.,
"Sheet 50 of
"). The total number of sheets will be placed on all the sheets when the
"as-built" drawings are prepared.
7.13 DESIGNATION OF TYPE OF DESIGN
Use "A-l," "M-6," etc.; as designations for architectural, mechanical, etc., drawings,
respectively. Place these designations in the "DIV. NO." block in the example title strip shown
in Appendix N. Refer to MIL-HDBK-1006/l for additional information.
7.14 DRAWING REVISIONS
7.14.1 Space for Revisions. The revision block location, size and format shall be as shown
in Appendix L.
7.14.2 Making Revisions. Revision block notations will indicate each time a change or
changes have been made to the drawings. The first set of revisions shall be designated by the
letter "A," subsequent sets of changes shall be designated by "B," "C," etc.
a. Each individual revision made on the drawings shall be identified with an Al, A2,
or A3, when there are three (3) revisions in the first set of revisions; Bl, B2, B3, B4
or B5 when there are five (5) revisions in the second set of revisions; and so on (i.e.,
a capital letter followed by a numerical subscript). The entire revision shall be
enclosed in a "bubble" or "cloud."
b. In the "LTR" column of the revision block, the capital letter together with the
subscript of the last revision shall be circled. In other words, if there are three (3)
revisions in the first set of revisions, the drawings change shall be identified by an
A3 placed in a circle.
7-9
|
 
|
|
|
||
