Custom Search
|
|
|
||
 Use a wire brush to clean off any loose paint or corrosion. Use thermal epoxy to
secure the sensor to the tank.
FIGURE 5-33 Installing
a Sensor on a Tank
Wall Stud
FIGURE 5-34
Clamping the High
Limit Sensor to Tank
Outlet
Back-Up Heating Element
Turn off all electrical power to the tank element(s). Drain the tank, unbolt the
element flange and remove the old element. If the new element includes a new
gasket, scrape the old one off the tank and discard it.
If no new flange is available, remove the old element flange carefully. Install the
new element, using the new gasket, or gasket repair compound on an old one.
REPAIR
194
5.2 REPAIR PROCEDURES
|
 
|
|
|
||
