Stainless-ARC (all steels - medium,high carbon, alloy, and tool steels

Custom Search

Back
Zinc Die Cast and Aluminum

Up
Welding Materials Handbook

Buildup-ARC (tungsten, high speed)

Secondary: Can be used for welding stainless (no

TYPE: STAINLESS - ARC (all steels - medium,

acid) and salt-water pipe lines. Can be applied as a

high carbon, alloy, and tool steels)

buildup on manganese steel or any wear problem

AWS-ASTM E 312-16

involving frictional wear and impact.

NSN: 9GD

14)

PROCEDURES:

9GD

14)

Bevel 90. Preheat alloy steels to 400F. Hold a

9GD

14)

short arc. Use stringer beads. Run intermittent welds,

9GD

14)

especially on high alloy steel. Peen lightly to relieve

stresses.

POSITION: All

CHARACTERISTICS:

POLARITY: AC or DC Reverse

Bare rod can be applied with gas or GTA torch. Since

many other rods are capable of doing jobs that this rod

RECOMMENDED AMPERAGES:

can do, conserve supplies and use it only for jobs

3/32 - 50 to 90

requiring its high tensile strength properties.

1/8 - 90 to 120

5/32 -120 to 160

Tensile Strength: 120,000 psig

3/16 - 150 to 190

USES:

Primary: Use this rod when you need a high

strength weld deposit or when highly stressed joints,

vibration or shock continually cause weld failure. Use

on all steels and where destructive combinations of

wear, impact, corrosion, or heat are present.

1-20