DEDUCTIONS*
VALIDATED REWORKED
MADE
WORK
CUSTOMER
BY
PREVIOUSLY
REQUIREMENTS
COMPLAINTS CONTRACTOR
A.
Response time
3
N/A
51
B.
Classification
3
3
35
C.
Cost accounting
3
3
25
D.
Quality work
3
3
10
For work requirements B, C, and D, credit for rework is given for defects
reworked. Since RSED was used, the number of defects for which credit is
allowed, cannot exceed the number of new defects for which deductions were
previously made. Because the number of defects is less than the number for
which deductions were taken as a part of the previous calculation, there is
no such limitation in the credit in this case.
* See line m of RSED payment calculation, Figure 6-4.
OTHER ADJUSTMENTS
WORK REQUIREMENTS
PAYMENT
RESPONSE
CLASSI- COST QUALITY
CALCULATION
FICATION ACCNTG WORK
TIME
Credit for no. services
N/A
3
3
3
reworked
Price per service
N/A
$ 1.00
$ 1.00
$ 12.00
Credit for rework
N/A
$ 3.00
$ 3.00
$ 36.00
Deduct for liquidated
$ 0.00
$ 0.30
$ 0.30
$ 3.60
damages
Credit for rework
$ 0.00
$ 2.70
$ 2.70
$ 32.40
6-682 Computer Program. A RSED computer program for calculating
payments, is available from the EFDs. This computer program may be used for
100 percent inspection, planned sampling, random sampling for extrapolated
deductions, and for random sampling without extrapolated deductions. The
manual calculation of the typical payment calculations shown in this manual
should rarely be necessary.
6-700 REMEDIES There are a number of strategies for correcting poor
performance. The following actions should be initiated when unsatisfactory
performance first becomes evident.
6-710 Review of the Contract Documents. The contract documents should be
reviewed to determine if the unsatisfactory performance is to some degree
caused by the Government's erroneous interpretation of the provisions of the
contract.
(a) If the Government is requiring standards of work higher than those
specified in the contract documents, either the required standards must be
relaxed to conform with the standards as specified, or the contract must
127