| Tweet |
Custom Search
|
|
|
||
 TRACTOR PARTS AND ACCESSORIES
(Continued)
Bulldozer End Bits
Ripper Teeth (Continued)
Carbon Steel
Welding Procedures: Apply to top and sides of tooth
covering area about 2 in. back from point. Hard-face
Primary Electrode: Page 1-25
remainder of tooth as shown in Figure 2-11.
Alternate Electrodes: Pages 1-22, 1-20
Welding Procedures: Place end bit in flat position and
apply beads across outer comer and along edges. On
worn end bits, weld new corner and hard-face (Figure
2-12). If work involves impact, use above mentioned
electrodes; in case of severe abrasion and moderate
impact, use electrode on page 1-26.
FIGURE 2-11. Hard-Facing Ripper Teeth
2-22
|
 
|
|
|
||
